DIY: Pendant from Brass Tube Offcuts

DIY PENDANT FROM BRASS TUBING OFFCUTS

If you thought my rubber and brass tube necklace was simple, this pendant is even more so!

DIY PENDANT FROM BRASS TUBING OFFCUTS

The pieces come from the same batch of tubing offcuts in the previous post. This time  6 pieces of metal tube the same diameter and graduating lengths (approx 1″ and smaller)…

DIY PENDANT FROM BRASS TUBING OFFCUTS

I played around with arranging them and settled on this staggered configuration…

DIY PENDANT FROM BRASS TUBING OFFCUTS

Then grasping one of the tubes with a set of small pliers…I simply super glued each tube in turn along the length, holding in place for about 30 seconds before moving onto the next….(be sure to use a glue suitable for metal)

DIY PENDANT FROM BRASS TUBING OFFCUTS

Leave to dry…

DIY PENDANT FROM BRASS TUBING OFFCUTS

Thread onto a piece of leather, rubber, or your favourite chain!

Doesn’t get easier than that, right?!

Tweet about this on TwitterShare on FacebookPin on PinterestGoogle+

2 Comments

  1. m(i)e November 16, 2015

    nice one !!!!

    Reply
  2. Michele November 16, 2015

    Love this one too. You are so amazingly creative.
    Cheers, Michele

    Reply

Leave a Reply

Your email address will not be published. Required fields are marked *